egcivic94

I just recently got a t3/t4 turbo and making a downpipe, the flange did not come with any gaskets for the 5 bolt pattern, could I just use high temp silicone or some kind of gasket maker and call it good? or should I just get a gasket, the problem is I can't seem to find one for the 5-bolt turbo.

J-MAN

just get the gasket, you can run it without one but why not just run one? exhaust leaks suck *** . cool for dates because then you can just turn your heater on and she will pas out but other then that it sucks. just find out what car it came off then goto the dealer and ask them to order you one.

egcivic94

it is a turbonetics t3/t4, their website does not list a gasket for a 5-bolt patern, I think they call it a 5-bolt ford patern is it the same one of the ford t-3's?

4g63t_EGMonster

try and email them, they should be able to guide you in the right way.

leed

Ive always just made my own. Ive used both sheetmetal and currently using a coper one. You can just make a trace and then dremel one out.

twin911

Go to the parts store and buy a sheet of gasket paper for about 12 bucks, trace it and cut it and you have your self a fancy gasket, you will even have enough left over to make all sorts of other gaskets.

egcivic94

thanks for to input guys! I'll go look at getting some gasket making materials, after all this is HOMEMADE TURBO!!!

ifly87

where do you get that copper gasket material?

1991civicsi

http://www.roadraceengineering.com/f...andgaskets.htm
Scroll down to bottom of page

djfob

I've never had a problem not running a downpipe gasket