exhaust housing swap??
 

AiResearch/Garrett M10 t4


i have a t4 . 60 ex .81
its got a 3in v band
no shaft play
the ex side is far to big for my d16 .. i have searched doing a swap over to a t3 exhasyed side but cat find any thing :3.
so what im asking is has anyone on here done a swap on this turbo? can it be done? i want to drop down to like 63 ar size
thanks for any help

Re: exhaust housing swap??
 

just buy this, it's a .69 hot side, perfect.

http://cgi.ebay.com/ebaymotors/Genui...1%7C240%3A1318

Re: exhaust housing swap??
 

looking ro swap over sides but i did bid on it .

Re: exhaust housing swap??
 

You'll have to convert it to a T3 turbine wheel if you want to run a T3 hotside. Hence the T3/T4. Your predicament isn't uncommon haha. The T4 compressor is perfect, but the T4 turbine wheel and hotside aren't. It's about $300 to do it properly. If it's a small enough T4 turbine wheel you could probably find a stage 5 (T350) turbine housing and have it bored slightly over for the T4 turbine. It would still spool like ass with the T4 turbine wheel in it though.

Re: exhaust housing swap??
 

bump

Re: exhaust housing swap??
 

wanna trade a nissan t3 for ur t4?

Re: exhaust housing swap??
 

what ar sizes is it and is there any shaft play

Re: exhaust housing swap??
 

don't know the AR size. Yes there's a lil shaft play. Its a water and oil cooled Nissan t3 from a single turbo z31. Its got a goofy 7 bolt DP flange that is like $30
Where are you located?

Attachment 10289
Attachment 10290
Attachment 10291
Attachment 10292
Attachment 10293
Attachment 10294

Re: exhaust housing swap??
 

i have two homes lol when im in school 60188 but my mom and dad live in 50707 so check on both places for shipping
wish i knew the ars on that tho

Re: exhaust housing swap??
 

pm'd

compressor inlet measure ~52mm
and the turbine outlet measure ~50mm

I have an extra compressor wheel I think it is...and a shitty as plastic dial caliper that gives "~measurements"

Re: exhaust housing swap??
 

thanks i am doing some searching on the turbo to see if shell meet my goals and what i would have to do to get to my goals what is the extra compressor size?
that is if you do stil have it

Re: exhaust housing swap??
 

the wheel is from the same turbo, just a spare one that I got from someone, and its a compressor wheel

at the widest point its 60mm
and at the narrowest point of the fins its about 47mm

If its not what you're looking for...no worries. It'll put me close to 270whp in my stock h22, I just don't know how much boost i'll have to run to get around there, so it'll be fine for me until I can afford a build project.

Re: exhaust housing swap??
 

im deff looking at the turbo for a real trade ilike i have posted i want to runing someing smaller on my d16. ill get oics of my turbo asap