sup nogs,

i just finished soldering/wiring up my 450's to a set of inline resistors, now my question is; will the stock injectors seals in my fuel rail work if i hollow them out? I noticed on the write up NAPA's injector seals sit a little higher, which puts the 450's at the stock placement inside the intake runners.. any advice would be appreciated

 

wow, dude there is like sooooo much info on this all over the web.



you must feel like a idiot.

 

stfu the hmt tutorial says to use napa seals.. but i've been told you can stuff them into stock seals resulting in the tip sitting too low.. just looking for some answers without reading a hundred pages just to find one answer



home made gauge holder: 1 clamp, 1 screw

 

Bore out your stockers with a dremel and your good to go

 

thanks chris