DSM 450cc's in a honda fuel rail.. NAPA injector seals required??
 

sup nogs,

i just finished soldering/wiring up my 450's to a set of inline resistors, now my question is; will the stock injectors seals in my fuel rail work if i hollow them out? I noticed on the write up NAPA's injector seals sit a little higher, which puts the 450's at the stock placement inside the intake runners.. any advice would be appreciated

Re: DSM 450cc's in a honda fuel rail.. NAPA injector seals required??
 

wow, dude there is like sooooo much info on this all over the web.



you must feel like a idiot.

Re: DSM 450cc's in a honda fuel rail.. NAPA injector seals required??
 

stfu the hmt tutorial says to use napa seals.. but i've been told you can stuff them into stock seals resulting in the tip sitting too low.. just looking for some answers without reading a hundred pages just to find one answer
http://a441.ac-images.myspacecdn.com...8518e22950.jpg


home made gauge holder: 1 clamp, 1 screw
http://a623.ac-images.myspacecdn.com...fa6bcfbca6.jpg

Re: DSM 450cc's in a honda fuel rail.. NAPA injector seals required??
 

Bore out your stockers with a dremel and your good to go

Re: DSM 450cc's in a honda fuel rail.. NAPA injector seals required??
 

thanks chris :)