Day 3 battle, leaky oil feed. *pipe up stevemode*
#23
Re: Day 3 battle, leaky oil feed. *pipe up stevemode*
I have used the banjo bolt with the stevemode line, what I did was took a three inch section of rubber hose and clamped it around the banjo side than slipped the other side over a threaded fitting which was screwed into the stevemde line, clamped it up and never had to cut the stainless line. worked fine for me.
#24
Re: Day 3 battle, leaky oil feed. *pipe up stevemode*
Originally Posted by daubleaaron
I have used the banjo bolt with the stevemode line, what I did was took a three inch section of rubber hose and clamped it around the banjo side than slipped the other side over a threaded fitting which was screwed into the stevemde line, clamped it up and never had to cut the stainless line. worked fine for me.
#25
Re: Day 3 battle, leaky oil feed. *pipe up stevemode*
I had the same problem with the oil fitting adapter so this is what I did. I cut the stock Banjo fitting and drilled it out then tapped it for a 1/8 npt pipe thread.
Or you can get one of these:
Or you can get one of these:
#29
Re: Day 3 battle, leaky oil feed. *pipe up stevemode*
Originally Posted by Stealthmode
That banjo tapping is the ----. Good work.
thats very hmt style.
i dig. i might buy that banjo thingy at the bottom, im tired of trying to deal with this fitting and it seems like the easy way out.
all i gotta know is which i should buy.
options are
Banjo Adapter -4 male to 7/16 Hole diameter .425 height (this looks like the winner, the opening is about 12mm, which converts to .462" which is about 7/16 (7/16=.437)
Banjo Adapter -4 male to 10mm Hole diameter .425 height
Banjo Adapter -4 male to 3/8 Hole diameter .425 height
Damn, $6.18 to buy it....$7.57 to ship it. Cmon it weighs like an ounce.
Thread
Thread Starter
Forum
Replies
Last Post