what are the bends that are needed for the charge pipings? like i know u need 2 90 degrees but what else?

 

in general you will need 4 180's and a 45

 

just go get a gang of 180s and some straight stuff from Napa. Can't hurt to have bends around for ----.

 

its better to have enought. than to be short at the last minute.

 

Without knowing anything about your setup, no one can answer your question.

I made a little 3D sketch of what I thought mine would look like. Estimate the bend angles and use a measuring tape to approximate the lengths. It's really not that hard...

 

right on dudes....yea just buyin a bunch of 180's sounds the best, that ***** cheap anyways

 

is that website a good one too buy from? like is the ---- straight

 

noob