B16A2 at the rollers(now with power graphs!!)
:'( went to the rollers yesterday and was very very very disapointed with the results!
200hp at the flywheel and 149lb/ft torque! WTF? Is this the normal for a B16A? my setup is, T3 .42, .48 ss autochrome manifold 450's and inline resistors Apexi Vafc 2.25 exhaust from turbo back with a apexi N1 Muffler. MY settings are wide low 1k 42 1k 40 2k 36 2k 36 3k 30 3k 30 4k - 8k 42 4k - 8k 42 started off with 36 across the board on high and low, and got 187hp and 146lb Im not sure where my timing is at, as he didnt check it, could this be my problem? The boost gauge is showing 5pi all through the rev range so it cant be the turbo. Please help as i have spent a lot of money to get this setup done and i dont want this to be the final result! |
Re:B16A2 at the rollers
you're only running 5psi man! Can't expect huge gains from that. stock is 160crank hp and 112 ft/lbs @ the crank.
yours are at the wheels right? |
Re:B16A2 at the rollers
200hp an 149lb at the crank!
|
Re:B16A2 at the rollers
really though man, 5 psi :-\ can't expect too much out of it, why don't you raise the boost, perhaps a bigger turbo? you can easily run 8-10 safely with your set up......
|
Re:B16A2 at the rollers
i would at least be at 8-10 psi, but that's just me. it would feel like a waste of time to build a turbo and only run 5psi.
|
Re:B16A2 at the rollers
200 hp at the crank is about right for 5 psi on a B16.
stock 160 hp 5 psi adds 40 hp...it's all good that's about 7.5 hp per pound take it to 10 psi and you'll get to 240-250 easy...I would use a 63/60 T3 turbo you will make more power with it |
Re:B16A2 at the rollers
i have your exact same setup, except for Fuel managment i have a 12:1 FMU, same turbo size too, do you still have your cat on?
|
Re:B16A2 at the rollers
im running 6.5 PSI with a test pipe and my car pulls strong all the way untill 8000 RPM, so its not the turbo, i dont have any numbers but if i had to guess would say im in the 220 HP range, my friend has a 99 eclipse GST running 17 PSI with 3" downpipe 3"cat and 3" cat back and i smoke him everytime even with another person besides me in my car and only him in his.
|
Re:B16A2 at the rollers
a T3 .42/.48??? WTF? That's wayyy too small for your B16a. Run at least a .48/.60 !!! maybe thats why... Small turbo, small gain...
|
Re:B16A2 at the rollers
what kind of "rollers" measure flywheel horsepower? you unbolted the tranny and bolted it up to an engine dyno or what?
|
All times are GMT -5. The time now is 02:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands