another diy manifold thread
#1
another diy manifold thread
I am about to try to make my first manifold... I am kicking around the idea of trying a twin turbo maniofld, simply because I have 2 stock turbos sitting in my garage off of a 95 supra...
I know it will be hard, but it shouldnt cost much money since I have the turbos already...
basically I was curious if anyone had seriously mulled this over before and came up with any manifold design ideas
btw.. this would be for a b18c
I know it will be hard, but it shouldnt cost much money since I have the turbos already...
basically I was curious if anyone had seriously mulled this over before and came up with any manifold design ideas
btw.. this would be for a b18c
#2
Re:another diy manifold thread
here is a twin turbo setup B18c, unknown how it works... because its not done.. and I have no other info
I honestly think it would be a waste of time, single setups can make more than enough power.
Jeff
#3
Re:another diy manifold thread
I know you can make enough power with one.. that wasnt the point.. I am trying to make my kit out of nothing but "junk" in my garage, except the manifold, which I will be building myself regaurdless...
that pic looks cool.. I gues you have to plumb the #1 & #4 into one and the #2 & #3 into the other? that kinda sucks.. my turbos are half the size of the ones in the pic so room shouldnt be as much of a problem...
that pic looks cool.. I gues you have to plumb the #1 & #4 into one and the #2 & #3 into the other? that kinda sucks.. my turbos are half the size of the ones in the pic so room shouldnt be as much of a problem...
#4
Re:another diy manifold thread
i had an idea of a twin turbo stup by custom making a header and intake- making it have a throttle body on each end of the intake and using small turbos for 2 cylinder. i would like to do a turbo project like this i had the money
Thread
Thread Starter
Forum
Replies
Last Post
OneBadV6
Forced Induction
9
01-25-2011 05:45 PM