Re: 1st turbo setup and car won't start!!
 

ok i have another question i'm not sure about, when i run the engine at idle the a/m oil pressure gauge reads about 80psi and when i slightly rev the engine to say 2-3000rpms it jumps up to about 100psi... is that normal?? i have a tee off the back of the block with the oil feed line going to the left and the sender unit straight off the back. thanks again.

Re: 1st turbo setup and car won't start!!
 

Idle should be like 40psi I think. I don't have a guage, but I'm 99.832% positive 80psi is much too high.


JP

Re: 1st turbo setup and car won't start!!
 

i got the oil pressure situation fixed, the car just needed to warm up, it idles at 12-15lbs like its supposed too. The car is at the exhaust shop right now getting the IC piping and the downpipe put on...i'll post some pics and maybe a vid when its done!!

Re: 1st turbo setup and car won't start!!
 

glad you got it running bro! get the new chip and use the 450s, and get it tuned unless you want a car that wont start again, ever