Re: 1st turbo setup and car won't start!!
 

change the plugs and tell us if it starts, i think it should still start with the ones you have but who knows, turbo motors can be testy sometimes

Re: 1st turbo setup and car won't start!!
 

yeah i'll try that tomorrow night

Re: 1st turbo setup and car won't start!!
 

also will probably want to gap it down a bit farther around .028

Re: 1st turbo setup and car won't start!!
 

yeah i will deff. try that, let me know if you think of anything else

Re: 1st turbo setup and car won't start!!
 

This is exactly what my car did when I tried to start it with 450's in it and the computer was set up for stock injectors. I think that's your problem. I don't see anything that says your chip is setup for 450's...

Re: 1st turbo setup and car won't start!!
 

fix that wiring mess on the injectors before your ---- burn up, put new plugs in it and gap around .028-.027 bet the bitch starts

Re: 1st turbo setup and car won't start!!
 

or resistor box

Re: 1st turbo setup and car won't start!!
 

wiring mess? i have it visible like that for the photo so you can see, every connection is soldered and i used the 10watt 10ohm resistors just like in the dsm injector install... each one is hooked up to the 4 common yellow/black wires. Once i'm done the will get taped up more and i'll put wire loom around that

Re: 1st turbo setup and car won't start!!
 

dude i got a resistor box your for 25 shipped, dont use tape to seal the connection go get some shrink tubing, cheaper then good electrical tape

Re: 1st turbo setup and car won't start!!
 

inline resistors are fine, as long as it soldered and insulated its ok. its probly your ecu. or your blue valve cover/autolite plugs.