traction bar radius rod length question (with finished pics)
#52
Re: traction bar radius rod length question (with finished pics)
Danz, have you had any experience with the check-valve-crankcase evacuation stuff before?
I've thought about doing it in the past, mimicking V8 dragsters who run a line straight from the valve cover to the exhaust, but ditched the idea- simply b/c I reasoned it would eat too much oil by causing a little excessive low-pressure in the case.
I'd like to see how you have yours setup, please!
I've thought about doing it in the past, mimicking V8 dragsters who run a line straight from the valve cover to the exhaust, but ditched the idea- simply b/c I reasoned it would eat too much oil by causing a little excessive low-pressure in the case.
I'd like to see how you have yours setup, please!
#53
Re: traction bar radius rod length question (with finished pics)
no experience what so ever.
i have two lines off the black box (1/2in ID) going to the catch can (drain back) and one 1/2in ID going from the VC to catch can.
here you can see the breather fitting connected to my hmt catch can (2.5in exhaust tube capped with 1/2in tube welded to it, and 1in ID tube for breather)
this line goes behind the rear cross member to the slash cut
now if i can get the 3 bar working with TE 3.1.7 this ****** will be mad hmt.
i have two lines off the black box (1/2in ID) going to the catch can (drain back) and one 1/2in ID going from the VC to catch can.
here you can see the breather fitting connected to my hmt catch can (2.5in exhaust tube capped with 1/2in tube welded to it, and 1in ID tube for breather)
this line goes behind the rear cross member to the slash cut
now if i can get the 3 bar working with TE 3.1.7 this ****** will be mad hmt.
Thread
Thread Starter
Forum
Replies
Last Post
mij_nagrom88
General Discussion
19
11-27-2006 02:44 PM