HomemadeTurbo - DIY Turbo Forum
Page 3 of 5
1
2
3
4
5
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Fabrication (https://www.homemadeturbo.com/fabrication-14/)
-   -   My intake manifold fab. (https://www.homemadeturbo.com/fabrication-14/my-intake-manifold-fab-98607/)

redline6k 04-21-2009 05:06 PM
Originally Posted by Sroufe7 (Post 1266594)
What did you use to round the inside of the runners?
Router with a 3/8 round over bit.

bkeller143 04-21-2009 09:30 PM
good

bkeller143 04-21-2009 09:30 PM
times

bluebomber 04-22-2009 01:23 AM
Plan on taking it to a flow bench?

Sroufe7 04-22-2009 07:30 PM
Originally Posted by redline6k (Post 1266760)
Router with a 3/8 round over bit.
Did you do anything special to not have the bit clogged with aluminum shavings?

Henson87 04-22-2009 08:04 PM
Nice mani!!!!!

silvertc 04-23-2009 10:46 AM
not to bad..

twack 04-23-2009 12:07 PM
looks good i would have i boost leak test to see if you have any pinholes in your welds

redline6k 04-23-2009 01:00 PM
Originally Posted by Sroufe7 (Post 1267035)
Did you do anything special to not have the bit clogged with aluminum shavings?
I sprayed the peice and the bit with wd-40 and i went pretty slow with it.

shoyass 05-25-2009 08:17 AM
Originally Posted by redline6k (Post 1266208)
Before I do my next one I'm going to buy a welder with more amps. The 200 amps limits my ability to do much aluminum work.
200 amps is more than enough to do aluminum. Does your machine not have a balance or a freq. adjustments?


All times are GMT -5. The time now is 04:43 AM.
Page 3 of 5
1
2
3
4
5
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands