My intake manifold fab.
I don't really do much aluminum work. I need quite of bit of work still. My consistency isn't great and I need to work on my starts and stops. I incorporated the velocity stacks into the plenum floor. The welds from the runners to the stock flange suck. I tried my best to clean the cast aluminum but nothing worked too get it perfectly clean. I thought I would post it up on here and hopefully get some advice on what I'm doing wrong. Thanks.
http://i6.photobucket.com/albums/y21...e6k/002-13.jpg http://i6.photobucket.com/albums/y21...e6k/003-11.jpg http://i6.photobucket.com/albums/y21...ne6k/004-8.jpg http://i6.photobucket.com/albums/y21...ne6k/005-5.jpg |
Re: My intake manifold fab.
What you need help on? Clean, use some carb cleaner.
|
Re: My intake manifold fab.
Need more consistency with head and filler. Don't stop/start so much. Clean cast runners with A/C current, brush off contaminants, repeat a few times. Done. Did you do those velocity stacks with a router?
|
Re: My intake manifold fab.
What's the purpose of the stacks if their flush with the plenum? I thought if your using stacks then to mount them so their raised inside the plenum? Overall looks better then what I can do.
|
Re: My intake manifold fab.
hotter and and faster. Welds are just plain old too cold.
|
how much hp improvement do you get
|
Looks nice so far
|
looks good to me..........
|
nice work
|
Round it out a bit?
|
All times are GMT -5. The time now is 05:44 PM. |
© 2024 MH Sub I, LLC dba Internet Brands