manual exhaust cut out
Guest
Posts: n/a
Re: manual exhaust cut out
Originally Posted by JoshMO
Correction on that Jago you're wrong about that.
The ID on this TB is 2.5" which (in my opinion) is pretty damn good for what you're wanting to do.
The ID on this TB is 2.5" which (in my opinion) is pretty damn good for what you're wanting to do.
b7 TB=56 mm
Why did you agree about the 2.2" earlier? You know nothing.
3.0 BAR
Joined: Jan 2007
Posts: 1,563
Re: manual exhaust cut out
Originally Posted by jagojon3
No it's not. Try measuring at the IM side.
b7 TB=56 mm
Why did you agree about the 2.2" earlier? You know nothing.
b7 TB=56 mm
Why did you agree about the 2.2" earlier? You know nothing.
because I remembered measuring the intake side earlier this week and it was 2.5". However, I didn't take it off and measure the IM side. You jump to conclusions and are vague with your answers... you know nothing.
. To the op GOOGLE is your friend.
1.5 BAR
Joined: Mar 2005
Posts: 723
Re: manual exhaust cut out
Just get almost any TB and the throttle cable, a square plate of steel, and a tube the size of the TB. Mount it to plate, cut big hole, weld the adapter to exhaust, route cable inside. OBD1+ B-series = 60mm, most d's = 56mm, ford 4.6L (crown vic, mustang, etc) = 65mm. I just bought 2 ford TB's for $20/shipped each and plan to hook the cable up to an 8lb solenoid. WOT activates switch, auto-cutout in 1/10th of a second.
BTW if you look in the Yellow Pages you'll find some rental places around you. Homeboy Depot also rents them at most stores. Fluxcore madness!
BTW if you look in the Yellow Pages you'll find some rental places around you. Homeboy Depot also rents them at most stores. Fluxcore madness!
Thread
Thread Starter
Forum
Replies
Last Post
