Made a turbo header today :)
#1
Made a turbo header today :)
But no up close pictures
But there are some pictures at the bottom of the page on this link
http://www.eville140.com/starlet9.html
Later
Randy
But there are some pictures at the bottom of the page on this link
http://www.eville140.com/starlet9.html
Later
Randy
#10
Re: Made a turbo header today :)
The log mainfold was the first try, it probaby would of worked just as well. But I wanted something that mounted the turbo up a little higher. The engine looked a little lopsided with the turbo mounted down low.
Plus I have a little downtime while I wait for the seats to arrive so I can finish the cage.
Going to make a stainless minfold from weld L's next, the one I just made is from 1 5/8" 16 gauge steel j-bends (and it was a PITA)
Later
Randy
Plus I have a little downtime while I wait for the seats to arrive so I can finish the cage.
Going to make a stainless minfold from weld L's next, the one I just made is from 1 5/8" 16 gauge steel j-bends (and it was a PITA)
Later
Randy