racepak

so i got my 220v HF tig.
i plugged it to the wall and bam. it short circuited the electricity at my house.

i got it as new from EBAY HF before about 3 mounts ago. they shipped it to my uncles house and then he shipped to me (to israel). so it took some time.

i'm gonna open it in a few minutes to see whats going on inside.

can anybody help me and tell what to check?

thanks.

SpankedYA!

Did it come with a plug or did you install it?

2point2

"Israel 230V 50 Hz, Jerusalem 220V 50 Hz"

North America is 60hz my friend.. I'm not an expert with AC voltage but that's my first guess as to what went wrong..

racepak

i installed the plug.

so it its lower here in israel it shouldnt have jumped.... i think.

clwtwizted

but welders have a bridge rectifier that makes it dc so the htz wont matter

SpankedYA!

Are you sure you didnt mix up L1 or L2 with the ground wire?

Eville140

That's what I am betting also. I'm sure their quality control sucks..but I doubt a dead short would make it out of the factory.

Later
Randy

racepak

i used the green wire for ground.
the other two dosnt mater.

BigWheeze

Most if not all can run 50hz or 60hz.

What brand and model is the machine. Find the HF card smell the boxes if you smell a burned area you fried the HF relays and you will need to have it replaced its just a couple plugs and pci style slot or just plugs or pci.

What amp service is it wired into?

scottsi

i didnt read anything but your avatar is mesmerizing