JB weld tranny
#12
Re: JB weld tranny
JB Weld doing WORK!
i might have to loosen that bolt, then put some weld on the bolt then tighten it to get a perfect seal but it seems to be holding just fine for now. another layer tomorrow and im calling it good hahahha
PS:---- those nice new 8" tall granite curbs
i might have to loosen that bolt, then put some weld on the bolt then tighten it to get a perfect seal but it seems to be holding just fine for now. another layer tomorrow and im calling it good hahahha
PS:---- those nice new 8" tall granite curbs
#14
Re: JB weld tranny
i let it dry overnight and i just put in a 1/2 qt of ATF and it seems to be holding just fine.
if its still holding in an hour ill fill it up and let it warm up. if it holds ill be more then happy hahah
if its still holding in an hour ill fill it up and let it warm up. if it holds ill be more then happy hahah
#16
Re: JB weld tranny
the mounts (2 bolts holes) for my slave cylinder on the d16 tranny were damaged on removal of the engine, like CHIPPED FULLY OFF off
Found all the parts in my garage, the aluminum from the bell housing that chipped off etc... Cleaned it/JB Welded the chipped off part, the slave cylinder, and the bolts back on and now 40,000 miles and 2+ years later...------- riding out still.
JB WELD FTMFW.
also
this is fact
Found all the parts in my garage, the aluminum from the bell housing that chipped off etc... Cleaned it/JB Welded the chipped off part, the slave cylinder, and the bolts back on and now 40,000 miles and 2+ years later...------- riding out still.
JB WELD FTMFW.
also
this is fact
I find jb qwik to be inferior to jb weld the og
Thread
Thread Starter
Forum
Replies
Last Post