i tried to convince him to go 3" but his budget was limited, so 2.5" it was.

 

very nice work Aaron - as usual

 

Aaron what size filler are you using? I switched from 1/16 to .035 for 16ga stuff and the results were favorable.

 

damn those inline pro manis set away from the head!!! i see them all the time on the shelf when i go to there shop but damn.. and as always Aarron GREAT WORK!!

 

thinkin the same thing you could put a football between the turbo and block

 

1/16". when i get low on filler, i will pick up some .035" but it is so much more expensive!

yeah, the inline pro does put it far away from the block, but the turbo wouldn't fit the other way because the compressor housing was hitting the block. not the best design in terms of space imo.

thanks for the compliments guys.

 

holy ---- dude

 

I think it would have been worth the extra effort/money to extend the dumptube under the oil pan.

Also with .035" wire, think MIG.

 

If it was me, I'd have used a shorter flex to allow the dump to go beyond the pan, but who cares when your on a budget

I'm sure that would fit a t3/t04B with the smaller cover a bit better, as I'm assuming he's not shooting for 450+ whp. Me thinks theres a good handful of people/resellers who'd trade a 57trim for the s- or v- (?) trim.