i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

i still need to add the wastegate on the d/s header, otherwise it is done. the downpipe is being a real ---- because it has to go under the m/c and then between the steering rod and the frame rail. it is going to have to be 2 piece, possibly 3. the p/s will be a cake walk in comparison. the car is a 1980 z28. he's aiming for 900whp. making the collectors was just retarded because just one single 2" pipe is big enough to cover the inlet on the t3 flange. i wanted to use 1.5" pipe, but the customer was adamant about using 2". :P there will be no intercooler on this setup. alcohol injection ftw!

http://i47.photobucket.com/albums/f1...M/SANY1676.jpg
http://i47.photobucket.com/albums/f1...M/SANY1677.jpg
http://i47.photobucket.com/albums/f1...M/SANY1678.jpg
http://i47.photobucket.com/albums/f1...M/SANY1679.jpg

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

Get it up front!!!! Looks good Aaron.

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

2" primaries are great, but he should have forked for straight T04s. All the same, that'll be nasty.

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

i say this all the time aaron..... ------ looks great as always

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

hey not to be a dick but it looks like that motor is crooked and that the turbo manifolds wont work right

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

That ---- is sweet! :o

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

all that needs it a y pipe intake system to a 6in Velocity stack in the middle of the grille

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT ins
 

In that setup, imho would have added the wastegates right to their respective turbine housings. For two reasons: You obviously don't have a ton of space to work with, and two, it would be the best path for flow, in this design, as far as letting off the pressure from each primary equally.

Also fwiw, turbine housings actually take weld quite nicely, just weld it off the turbo obviously... :1

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

I don't get it.

Two turbos AND a big block, and he's aiming for TT SBC numbers? :P

Looks nice, even though it's going into a gino mobile.

Re: i plan on getting paid for this setup once it is done BIG BLOCK CHEVY TT inside!
 

i resent that remark