---- using jb weld, try this instead!
#13
Re: ---- using jb weld, try this instead!
yea, when he did a 90* butt weld with aluminum diamond plate, then bent it over sidways with a monkey wrench..no cracks in the ----...man, im really looking into this ----...plus it hardens to be about as strong as steel. im sure if it can stop leaks in a boat, it can stop air pressure
#17
Re: ---- using jb weld, try this instead!
Ehh, repost, doc.
Hell, half of you people posted in the old topic :P
https://www.homemadeturbo.com/forum/...hp?topic=72474
I still think JB weld has its place in the world though, just my opinion
Hell, half of you people posted in the old topic :P
https://www.homemadeturbo.com/forum/...hp?topic=72474
I still think JB weld has its place in the world though, just my opinion
#18
Re: ---- using jb weld, try this instead!
Originally Posted by SinisterCRX
Ehh, repost, doc.
Hell, half of you people posted in the old topic :P
https://www.homemadeturbo.com/forum/...hp?topic=72474
I still think JB weld has its place in the world though, just my opinion
Hell, half of you people posted in the old topic :P
https://www.homemadeturbo.com/forum/...hp?topic=72474
I still think JB weld has its place in the world though, just my opinion
Originally Posted by c0mpl3x
ive used the aluminum brazing ----, and it's fairly good (hobart rods though) but prepping is extremely important. roughing the edges makes a nice difference
Thread
Thread Starter
Forum
Replies
Last Post
bense
Hybrid/Tech
11
10-16-2010 08:39 PM
GTI SYNCRO
Fabrication
6
11-25-2007 08:11 PM
kain
General Discussion
35
09-08-2005 11:42 PM