few pics of a ramhorn i just finished.
#13
Re: few pics of a ramhorn i just finished.
looks good, but you need to bring everything tighter to the block. You manifold runners have too much space between each other. Do you have a picture of the manifold on a car/engine with a trubo installed?
#17
Re: few pics of a ramhorn i just finished.
Is it all stainless steel. I have an xs power mani on my laser and it has carbon flanges and stainless tubes. looks good except the pipes are really dark and not pretty any more.
And yours look fantastic what kind of welder, rod, gas, are you using?
And yours look fantastic what kind of welder, rod, gas, are you using?
#18
Re: few pics of a ramhorn i just finished.
Hey Josh, nice mani... I like the trick with the inside runners with the extra piece at the flange. Looks like it makes that angle much easier to line up.
Hey hows that salmonella poisioning treating ya?
Hey hows that salmonella poisioning treating ya?
#20
Re: few pics of a ramhorn i just finished.
I think they are a little bit to ------ out. and i think you should add a 3/4 inch spacer where they go up so the turbo sits higher off the ground. the returns and down pipe are terrible if you dont do that.
Thread
Thread Starter
Forum
Replies
Last Post
b20accord
General Discussion
12
11-15-2005 03:33 AM
ssl2k
General Discussion
6
09-01-2004 01:53 PM