Fabbed up my first dP
#52
Re: Fabbed up my first dP
Originally Posted by 97EconoBox
------ A. I cant believe Im seeing people give some body ---- for Fluxin Exhaust on the first try out.
wtf happened to HMT.
This site that all you n00bs are on is about the low cash get it done your self kind of ----.
wtf happened to HMT.
This site that all you n00bs are on is about the low cash get it done your self kind of ----.
#54
Re: Fabbed up my first dP
Originally Posted by Towdogg
You should just buy a grinder and clean that ---- some! I live in middletown just so u know. You know anybody from down here ( newport/middletown area)
i havent even cleaned the pipe yet like most of the guru's said if its no going on your car dont ------- worry about it some header wrap and it will be fine ---- its already welded 3 times over if it breaks ill just go 6 i know im a newb my self but half of the new newbs have no room to talk you can pay some 1 100+ to fabb up a dp for you my car is made by me for me. ill blow your ------- doors off and if my downpipe should so happen to fall of i can say ---- it it cost 30 bucks leave it on the freeway and keep going. (End Rant not intened to people who talk ---- then give tips i know it ugly but hey it dont leak and its stuck together)
#57
Re: Fabbed up my first dP
Don't worry - you won't be able to get a gas weld to look like that unless you're melting the rod onto the surface, skipping over 1/2 inch and melting another gob, etc... make a puddle and dip - you'll do fine.
Colin
Colin
Thread
Thread Starter
Forum
Replies
Last Post
gogorider
General Discussion
0
07-03-2015 11:58 AM
kleenef
Fabrication
16
09-05-2009 10:08 PM