Because Ive never done it before? Never seen it before?

Perfectly capable 2 hands right here

Just wanna know there re assembled and any little tricks

The "manual" said to bring it to a shop, the manual isnt always the best way

 

it is really easy. you are over thinking it. you can lube the bearing, but use something very thin and make sure you put the snap ring back in

 

What size attachment would be used on a slide hammer to get the spindle off?
The ID of the wheel bearing is 1.475" so I could make a slide hammer with say a 1.3" ID and it would be perfect?



I got all the pieces to make it today at work perfectly

Just need to throw down 2 beads of weld

 

just make something that is held on by the lug nuts and use that with a slide hammer

 

just drive the hub out from behind.........hammer and black pipe nipple with cap

 

Thats what I wanted to do, just wanna know what size rod I can stick through the spindle and what size cap to use on the end of the slide hammer

I guess anything under the innner diameter of the wheel bearing would work......

 

kroil is good so is pblaster, but only if pblaster sits overnight does it really work good. I always just used a 5lb hammer to pop wheel bearings in/out