Re: Check how I get ganstsa!!!! JB weld inside
 

$37.70 Is not that bad for that nice clean part, but I am cheap


Still working on the return

Re: Check how I get ganstsa!!!! JB weld inside
 

Aslong as:
1) It is a clean surface that will give the epoxy grip (textured/sanded, ect)
2) The part does not get hot enough to allow the epoxy to uncure

Then it will probably hold.

Re: Check how I get ganstsa!!!! JB weld inside
 

should of taped hole and teflon taped in the fitting

Re: Check how I get ganstsa!!!! JB weld inside
 

Why?

Re: Check how I get ganstsa!!!! JB weld inside
 

A threaded in pipe fitting with epoxy or other high temp sealant on the threads would be held in mechanically rather than just relying on adhesive bond strength. That would be better, hopefully that's obvious.

Re: Check how I get ganstsa!!!! JB weld inside
 

This is HMT


Not honda tech

JB weld ftw

Also CaptainBondo, Check turbocivichatchs posts 50% of them are in my threads. Soooo I was being funny when I said WHY? Cause it don't need no teflon tape

Re: Check how I get ganstsa!!!! JB weld inside
 

It will hold.

Re: Check how I get ganstsa!!!! JB weld inside
 

If it doesn't hold take more pics!

Re: Check how I get ganstsa!!!! JB weld inside
 

i modded a s2 gsr mani to fit my b16 head and had to move the steel water neck so I cleaned it and jb'd it and it didn't hold. There was jb weld attached to both parts after though.

Re: Check how I get ganstsa!!!! JB weld inside
 

Thanks for the link, here is a pick. I'm still hoping the JB Weld works tho, that ----'s gansta.
http://www.shadetreetuner.com/conten...on/photo24.jpg