here is a manifold and dp i just finished. i figured it might save room and pipe if i put the wg tucked under the #4 runner. it turned out not too bad.

 

looks good, seen it a few times. nice execution as always.

 

omfg dude that is beautiful

i'd take that over full race any day

 

Nice bolt clearance... I like

 

oh ya powerfist engine stands
where steel toe shoes or

 

Thats clean as hell.

 

That's a bitchin wastegate also.

 

Very sweet indeed!

 

The WG location I don't see as anything special. It should work fine. I do think the WG should not be plumbed into the DP so early. It will create quite a bit of turbulance around the turbine which will reduce the efficiency of the turbine. Routing it into the exhaust is fine, but so close to the turbine, not so much. The only benefit I can see with this method is the fact flex pipe isn't needed on the dump tube.