wiring my vafc PLEASE HELP
#1
wiring my vafc PLEASE HELP
i have a d16z6 in my 89 hatch. i have it wired using the stock a6 wiring harness. i just bought a vafc and was wondering how to wire it, because they dont have the ecu pins for the a6, because its not vtec. they do have the obd-0 b16 that came in the siR. would the pins be the same excluding the vtec signal? if so then how do i wire the vtec in? I know someone on here has done this setup before, please help
#3
Re:wiring my vafc PLEASE HELP
for PM6 (88-91 civic/crx) or PG7 (88-89 1.6L integra) ecu application only
V-AFC VTEC controller ECU PIN location
Red & Orange wire splice/connect to A15 (yellow/black)
Green wire RPM signal splice/connect to B15 (white1)
Pink wire VTEC signal output to VTEC solenoid (green/yellow)
Purple wire VTEC signal input not used on PM6 ecu
Blue wire VTM signal not used on PM6 ecu
Gray wire Throttle signal splice/connect to C7 (red/blue wire)
Yellow wire Pressure signal output cut/connect to C11 ECU side harness
Si/Hf = white1 , DX = orange
White wire Pressure signal input cut/connect to C11 ENGINE side harness
Si/Hf = white1 , DX = orange
Black wire Ground splice/connect to A16 (brown/black wire)Engine side harness
Brown wire Ground splice/connect to A16 (brown/black wire)has to be connected closer to the ECU
got that off of mechanic_b. hope that helps.
**** out
V-AFC VTEC controller ECU PIN location
Red & Orange wire splice/connect to A15 (yellow/black)
Green wire RPM signal splice/connect to B15 (white1)
Pink wire VTEC signal output to VTEC solenoid (green/yellow)
Purple wire VTEC signal input not used on PM6 ecu
Blue wire VTM signal not used on PM6 ecu
Gray wire Throttle signal splice/connect to C7 (red/blue wire)
Yellow wire Pressure signal output cut/connect to C11 ECU side harness
Si/Hf = white1 , DX = orange
White wire Pressure signal input cut/connect to C11 ENGINE side harness
Si/Hf = white1 , DX = orange
Black wire Ground splice/connect to A16 (brown/black wire)Engine side harness
Brown wire Ground splice/connect to A16 (brown/black wire)has to be connected closer to the ECU
got that off of mechanic_b. hope that helps.
**** out
Thread
Thread Starter
Forum
Replies
Last Post
hondacrxflyer
Engine Management
1
06-05-2008 01:23 AM
racepak
Engine Management
0
12-01-2006 06:46 AM