wired in my MSD 6 AL, getting a code 15 car wont start.
#1
wired in my MSD 6 AL, getting a code 15 car wont start.
i have just wired in my MSD 6 AL to my CRX 89 ZC however im getting a code 15 when trying to start it. It is a possibility that i knocked the rotor arm out and the ignition timing is 180 degrees out, could that cause a code 15?
any help would be great
thanks
any help would be great
thanks
#4
Re:wired in my MSD 6 AL, getting a code 15 car wont start.
its wired exactly how anthony88 stated. I have not removed the internal coil. The msd box is still using the stock ignitor coil. The only thing i didnt do by the book is wire the black wire to the negative on the battery, i put it to the chassis instead but i cant see that causing a problem. Could my rotor arm of been pushed round while i was wiring so ive ended up putting the distributor back on with the wrong timing setup? it was a 50/50 on which way it could be. I'll reset the ECU then try again tonight...
#8
Re:wired in my MSD 6 AL, getting a code 15 car wont start.
I bet its ur groung wire.run that thing to the negative post of the battery.i tried that other way and later on it came loose from engine vibration.moved it to the baterry and had no problems since.
Thread
Thread Starter
Forum
Replies
Last Post
W O T
General Discussion
23
12-10-2005 05:16 PM
ComputerJLT
General Discussion
11
07-23-2004 10:22 PM