Will this computer work with my setup?
#2
Re: Will this compujter work with my setup?
If you want to chip it no. I can work, but by now means will it be easy. The do not have an external rom to work with. If you just want to run it as a Stock ECU. It will work, just may be a bit more fuel/timing as it's from a DOHC.
#4
Re: Will this computer work with my setup?
well i guess i could....but i would have to find one first. the only reason i am asking is because i have a PG7 sittin at my house and i was jus wondering if its usable or if its trash..
#5
Re: Will this computer work with my setup?
I used a PG7 with a D16 before.It ran a little rich though.I have like 4 or 5 PM6's in the garage if you need one.$25 shipped.The PG7 worked nice when i had a fairly aggressive cam,header and the usual bolt ons.You get a little higher rev limiter as well.
#7
Re: Will this computer work with my setup?
i wouldnt want a higher rev limit unless my engine can handle it..and i dont think it can. all the internals are stock so i would not want to put it past the 6500 rpm redline...
Thread
Thread Starter
Forum
Replies
Last Post
tman6919
General Discussion
23
02-16-2006 04:21 PM
biggmike
General Discussion
27
11-01-2004 09:00 AM