turbo edit properties
#1
turbo edit properties
so when i burn a chip, and set up all the stuff in properties like rev limits, fuel correction, injector sizing etc...and then i go back and read the chip, save and re-open the file, then go to properties, everything is reset to default #'s....WHY? is it supposed to do that? and you just have to go back through the properties and reset all that stuff every time you re-burn? also does it matter how the chip sits in the ecu socket? does the arrow on the chip NEED to point one way or the other? i know it matters for in the burner, but how bout in the ecu socket?
#4
Re: turbo edit properties
Originally Posted by boosted_b16
so when i burn a chip, and set up all the stuff in properties like rev limits, fuel correction, injector sizing etc...and then i go back and read the chip, save and re-open the file, then go to properties, everything is reset to default #'s....WHY?
Burn the chip, make changes, read the chip?
No no no silly boi, Make changes, Burn the Chip, Read the Chip.
#5
Re: turbo edit properties
Originally Posted by xenocron
The file should save whatever properties you give it.
What version of the code are you using? You should be using NG53 if you arent already...
What version of the code are you using? You should be using NG53 if you arent already...
Thread
Thread Starter
Forum
Replies
Last Post
cynosurecivic
Engine Management
4
10-25-2003 10:01 PM