TE and Ostrich
#1
TE and Ostrich
After fighting with Ostrich and TE 2.5.5 this weekend on WOT's car and never could get it to work. So we went to the burn a chip, pull over method.
What Settings are you guy using ( COM#, bit rate) and connecting methods?
Everything worked fine in chrome, so I know the hardware is fine.
What Settings are you guy using ( COM#, bit rate) and connecting methods?
Everything worked fine in chrome, so I know the hardware is fine.
#2
Re: TE and Ostrich
Bump for problems
Im gonna try drive home and burn method this week (no laptop), hopefully with the 3 bar map if you can send it to mw, and I gotta start reading, cause the boost portion of that tune was ------- sick
Im gonna try drive home and burn method this week (no laptop), hopefully with the 3 bar map if you can send it to mw, and I gotta start reading, cause the boost portion of that tune was ------- sick
#4
Re: TE and Ostrich
Just finished testing ostrich with TE 2.5.5 and it's working fine on my side. Make sure that the com port ostrich is using is the same as TE. Anyway I followed the instruction found here: http://www.moates.net/documentation....entation_id=15 and used the same setting . You might try to download TunerPro RT just for testing.
Here is my settings:
Ostrich (usb to serial converter, under device manager)
com port: 3 ( I had to manually change this since it was at com 7)
latency: 1
bits per second: 115200
data bits: 8
parity: none
stops bits: 1
flow control: none
TE (under options)
RTP COM port: 3
Good luck!
Here is my settings:
Ostrich (usb to serial converter, under device manager)
com port: 3 ( I had to manually change this since it was at com 7)
latency: 1
bits per second: 115200
data bits: 8
parity: none
stops bits: 1
flow control: none
TE (under options)
RTP COM port: 3
Good luck!
#5
Re: TE and Ostrich
Originally Posted by JK_Motorsports
No one?
Have at it!
Thread
Thread Starter
Forum
Replies
Last Post
TomBones
Engine Management
30
03-01-2009 05:30 PM
cloud
Engine Management
49
12-05-2007 02:41 PM
MyVtec8yourV8
Engine Management
4
01-07-2006 06:26 AM