Post screen shots of the process you are taking then I guess.

 

i open it

select the chip

then click erase, and set the jumper

then remove it after its done

then blank test

then it says device is empty

load a bin

burn it with 8000 offset

then it goes to 100% and fails

 

Email me or post the file you are trying to burn.

Have you tried any other files?

Your process sounds fine...

 

ive tried all the other ones that come with uber and a few of my own and nothing

 

have you tried that exact method with the 097g software? are you putting the chip in the burner after you have it powered up and the software open already? are you erasing the chip with the offset set at 0 or 8000?

 

im doing it like your write up, open software, set switches, put chip in, plung in usb, eraseing with 0 offset so whole chip is blank

 

looks like you dont have the software setup for the willem burner.

up at the top where it says PCB3 in bold blue letters, click thatand it will change to willem. start over and see if that works

 

bumping it up to see if you got this figured out yet

 

nope, the willem/pcb3 doesnt make a diff for me, im just going to ship them back to xeno