Re: p06 ecu converted to vtec problems....help please
Originally Posted by scttydb411
ck the diode (d11 i think) and the stripe should correspond w/ whats on the board. the tantalum cap should have a + on it that corresponds with the board also...make sure thats installed correctly too. i can't tell if j10 is jumped.
here are the parts you need: C60 - 1uF, 35v electrolytic (tantalum?) capacitor J10 - 0 Ohm jumper wire Q101 - A143 PNP switching transistor R201 - 10K resistor (Brown-Black-Orange-Gold) IC14 - 515 XHigh Side Switch D11 - Clamping Diode the parts differ from the 17 series board and are fewer, but commonly get confused between the 2. the switching transistor and highside switch get changed from c2785 transistor and 505 highside switch sometimes are found in the other board and get used in the 11 board and not work. jumper must be used if using only 1 515 highside switch. I also noticed that the solder isn't pushed through the front side. Back side looks fine but the solder isn't through to the front. From the front it looks like the pieces arent soldered. I need to send it out to get fixed right. I wish I could remember who I bought it from on HT. It was a year ago maybe. |
Re: p06 ecu converted to vtec problems....help please
If the diode in the top corner is in properly, and the cap i sin right, then I think that it should be okay.
|
Re: p06 ecu converted to vtec problems....help please
Ok duh. I see the J10 now. There is a jumper wire there. The cap above it looks ok. What do I look at next? I guess I can recheck the wiring tomorrow. I'll just run a new wire from the solenoid to the ecu I suppose. I've checked three dozen times though.
|
Re: p06 ecu converted to vtec problems....help please
The cap should look good, but also be sure that it is in correctly. There should be a + on the board, and a + on the cap matching.
Did the Diode match what was said? |
Re: p06 ecu converted to vtec problems....help please
nobody noticed there's no pnp transistor at q101 ;) that's your problem right there (granted the polarity on the diode (d11) and electrolytic capacitor (c60) is correct). here's what it looks like.
http://www.draglab.com/hmt/projektegdizzle/11f04.jpg |
Re: p06 ecu converted to vtec problems....help please
Beat me to it. Saw it as soon as the picture popped. Up.. but yea. he forgot the 1030 transistor. :-*
|
Re: p06 ecu converted to vtec problems....help please
Bah I just looked at the picture! I caught it too!
|
Re: p06 ecu converted to vtec problems....help please
Originally Posted by projekteg
nobody noticed there's no pnp transistor at q101 ;) that's your problem right there (granted the polarity on the diode (d11) and electrolytic capacitor (c60) is correct).
|
Re: p06 ecu converted to vtec problems....help please
Originally Posted by scttydb411
Originally Posted by projekteg
nobody noticed there's no pnp transistor at q101 ;) that's your problem right there (granted the polarity on the diode (d11) and electrolytic capacitor (c60) is correct).
|
Re: p06 ecu converted to vtec problems....help please
then lower the vtack changeover point 8)
|
All times are GMT -5. The time now is 07:06 PM. |
© 2024 MH Sub I, LLC dba Internet Brands