p06 ecu converted to vtec problems....help please
I have a p06 converted to vtec that I bought from someone on HT awhile back. The engine is a JDM d15b vtec with a 4 wire o2 from my old d15b7.
I went through the troubleshooting on PGMFi and if I burn a chip with a stock p06 bin from this website it doesnt get a CEL. I have tried the p28 bins and they all give a CEL code 21. The troubleshooting guide says its the program if the stock non vtec program works but the vtec bin I am using is a stock program from here http://www.pgmfi.org/twiki/bin/view/...efinitionCodes It is the p28-a01 I am using. I have checked the vtec solenoid and pressure switch and they are fine. I used the FSM procedure and I also tested the solenoid by jumping it and verifying the click. The wiring tests fine all the way to the ecu plug. Any ideas? Thanks, Aaron |
Re: p06 ecu converted to vtec problems....help please
Maybe who ever converted it did it wrong.
|
Re: p06 ecu converted to vtec problems....help please
I checked and all of the proper components appear to be present. I may end up replacing them myself but I'm hoping it is something more simple.
|
Re: p06 ecu converted to vtec problems....help please
Originally Posted by CSaddict
Maybe who ever converted it did it wrong.
|
Re: p06 ecu converted to vtec problems....help please
Have you tried a different version of Uberdata?
|
Re: p06 ecu converted to vtec problems....help please
I will have a pic in a few minutes.
Uberdata isnt a possibility. I used a stock bin from pgmfi. Untouched. |
Re: p06 ecu converted to vtec problems....help please
Originally Posted by CSaddict
Have you tried a different version of Uberdata?
|
Re: p06 ecu converted to vtec problems....help please
|
Re: p06 ecu converted to vtec problems....help please
If you see anything wrong with this pic please let me know. It is a 02d011f0 board.
|
Re: p06 ecu converted to vtec problems....help please
ck the diode (d11 i think) and the stripe should correspond w/ whats on the board. the tantalum cap should have a + on it that corresponds with the board also...make sure thats installed correctly too. i can't tell if j10 is jumped.
here are the parts you need: C60 - 1uF, 35v electrolytic (tantalum?) capacitor J10 - 0 Ohm jumper wire Q101 - A143 PNP switching transistor R201 - 10K resistor (Brown-Black-Orange-Gold) IC14 - 515 XHigh Side Switch D11 - Clamping Diode the parts differ from the 17 series board and are fewer, but commonly get confused between the 2. the switching transistor and highside switch get changed from c2785 transistor and 505 highside switch sometimes are found in the other board and get used in the 11 board and not work. jumper must be used if using only 1 515 highside switch. |
All times are GMT -5. The time now is 02:23 PM. |
© 2024 MH Sub I, LLC dba Internet Brands