o rings for fuel injectors
#2
Re:o rings for fuel injectors
NAPA sells an injector seal kit for $10 each.
You're looking for 92-95 D16Z6 seals if you plan on using DSM 450s. IF you already have a D16Z6, then you already have the seals you need... probably won't have to buy them.
I can't remember what motor you had with that S/C.
You're looking for 92-95 D16Z6 seals if you plan on using DSM 450s. IF you already have a D16Z6, then you already have the seals you need... probably won't have to buy them.
I can't remember what motor you had with that S/C.
#3
Re:o rings for fuel injectors
Originally Posted by TurboEF9
NAPA sells an injector seal kit for $10 each.
You're looking for 92-95 D16Z6 seals if you plan on using DSM 450s. IF you already have a D16Z6, then you already have the seals you need... probably won't have to buy them.
I can't remember what motor you had with that S/C.
You're looking for 92-95 D16Z6 seals if you plan on using DSM 450s. IF you already have a D16Z6, then you already have the seals you need... probably won't have to buy them.
I can't remember what motor you had with that S/C.
its a 99 civic si engine. i got 440 injectors, but the o rings werent sent for some reason, so i need to find somewhere to buy them asap. Would orilly's or pep boys have them?
#8
Re:o rings for fuel injectors
dude, geta dremel, if u don't have one borrow one and bore it out, make sure you clean all the resedue from the stock seals b4 sliding them into the manifold.took me 1 min to bore each on out to fit perfect. not too tight just perfect.
#10
Re:o rings for fuel injectors
I did not have to dremel mine, on a b16 with stock seals and dsm 450cc, all I did was install the seals on the injectors put them in the fuel rail, put some oil on the seals, and bolt the fuel rail down with 1-2 torgue patern so they get equal torque. no dremel you might make them too big.