o rings for fuel injectors
 

I need 4 o rings that seal the fuel injectors to the manafold. does anyone have these for sale or know where i can get them?

Re:o rings for fuel injectors
 

NAPA sells an injector seal kit for $10 each.

You're looking for 92-95 D16Z6 seals if you plan on using DSM 450s. IF you already have a D16Z6, then you already have the seals you need... probably won't have to buy them.

I can't remember what motor you had with that S/C.

Re:o rings for fuel injectors
 

its a 99 civic si engine. i got 440 injectors, but the o rings werent sent for some reason, so i need to find somewhere to buy them asap. Would orilly's or pep boys have them?

Re:o rings for fuel injectors
 

O'Reilly's might.. I don't have a Pep Boys around here, so I've never tried to buy parts form them..

Re:o rings for fuel injectors
 

so the seal kit that napa has is what i need?
Ill have to make some calls tomorrow.
do you know anywhere online that might have them?

Re:o rings for fuel injectors
 

And is the seal kit just for one injector? So the seals are gonna cost almost as much as the injectors?

Re:o rings for fuel injectors
 

dude.... just go to the Junkyard and look for an Acura with a b18.... those injector seals work too..... thats what i used... and best of all they were free.....

Re:o rings for fuel injectors
 

dude, geta dremel, if u don't have one borrow one and bore it out, make sure you clean all the resedue from the stock seals b4 sliding them into the manifold.took me 1 min to bore each on out to fit perfect. not too tight just perfect.

Re:o rings for fuel injectors
 

If you get the Napa kit, you will need to buy a todal of 4 kits. And dremel them larger. Mine were about 13$ Cad a set.

I'd prefer to use the new seals, over a crusty used set of seals.

Re:o rings for fuel injectors
 

I did not have to dremel mine, on a b16 with stock seals and dsm 450cc, all I did was install the seals on the injectors put them in the fuel rail, put some oil on the seals, and bolt the fuel rail down with 1-2 torgue patern so they get equal torque. no dremel you might make them too big.