MSD BTM... Need some help
#1
MSD BTM... Need some help
ok, i got an msd btm the one u use on your stock ignition, got it all hooked up except 2 wires(green, purple), it say i need to hook it up to the magnetic pick up, one + and one -,, cant figure out where to hook those wires up, its on a 91 integra ls, b18a1, Pr4
#2
Re:MSD BTM... Need some help
i have been trying to figure out what wires i hook my BTM up to because the directions don't say anything about honda dizzy, just ford and GM.
the instructions say that if you are using the white wire then you don't use the magnetic pickup wires.
the instructions say that if you are using the white wire then you don't use the magnetic pickup wires.
#3
Re:MSD BTM... Need some help
i found it brother
grey and black go to the control ****
purple and green you dont use
red goes to + side of coil, along with origional wire that hooked up to the coil
white hookes up to the origional wire that hooked up to the coil- side, and dont connect this back to the coil
black is a body ground
orange hookes up to the - side of coil
grey and black go to the control ****
purple and green you dont use
red goes to + side of coil, along with origional wire that hooked up to the coil
white hookes up to the origional wire that hooked up to the coil- side, and dont connect this back to the coil
black is a body ground
orange hookes up to the - side of coil
Thread
Thread Starter
Forum
Replies
Last Post
racepak
Engine Management
11
05-23-2006 10:11 PM