Every time i go in to try to change "analog out 1" voltage curve which is hooked to narrow band signal to the ecu and when i change the numbers and press "program" tab nothing happens, it just stops right there and the program tabs stays pushed on the screen.
I have the KOEO
I have the computer hooked to the serial OUT of the LC-1
I have the terminator in the IN

I don't know if i have a computer issue or a LC1 issue or maybe it is changing the settings but i really have no clue.

Please help

2000 civic si
b16a2
afc for now with stock ecu p2t
t3 netics


thanks

 

Close it and go back to the tab. Are the values the ones that you just inputted? I had the same issue, I think that it just works that way. When I went back to the tab, the values i wanted were there.

 

I will try hopefully late tonight, i know the last time i went back in to check it and it showed the factory settings, but then again it may have been something i did wrong.

Thank you!!

 

I don't think this has much to do with it, but this time i went ahead and renamed the Lc-1 and it took all the changes. It seems to work good now, crap the other night it got so screwed up and read extream lean to rich and i had to pull the sensor back out so i could recalibrate it like 40 miles from my house in the wal-fart parking lot.