What did I fry (batronix 3.3 programmer)
#1
What did I fry (batronix 3.3 programmer)
My little programmer is not working anymore. I have known working 27cs that I have tried to read, and at dec0/hex0 I am getting 00 instead of FF. So, what happened was.... I put a 27c in upsidown. Yeah, I know, stupid, well I plugged it into the wall, tried to read a chip, it gave me a screwed reading, I looked at my burner, and said oh ----, than unplugged it. I also am getting a 00 now at dec160/hexA0. My voltmeter is at work, so I can't do a proper hardware test right now, anyone had this happen?
#2
Re:What did I fry (batronix 3.3 programmer)
Originally Posted by cottagecreep
My little programmer is not working anymore. I have known working 27cs that I have tried to read, and at dec0/hex0 I am getting 00 instead of FF. So, what happened was.... I put a 27c in upsidown. Yeah, I know, stupid, well I plugged it into the wall, tried to read a chip, it gave me a screwed reading, I looked at my burner, and said oh ----, than unplugged it. I also am getting a 00 now at dec160/hexA0. My voltmeter is at work, so I can't do a proper hardware test right now, anyone had this happen?
Word of advice to everyone using the Batronix EEPrommer...don't put chips in backwards, especially overnight like I did
#3
Re:What did I fry (batronix 3.3 programmer)
Hurmm, I think I will be posting this question on the batronix website Perhaps I can take note, and figure out exactly what happened. I'd hate to have to re-order a new one. Mine was only in for about 15 seconds.
Thread
Thread Starter
Forum
Replies
Last Post
alwaystootall
Turbo Parts For Sale
15
10-11-2004 10:55 AM