Blake's working on RTP as we speak. He's actually looking for vounteers to test for him.

 

if he sends me an rtp board i'll test

 

Blake would never send anything like that...hell, he boycotted adding RTP because no one would buy his *** a ROMulator

 

i know, i'm thinking about getting an rtp set up so i can test for him. it will be worth it, i'm just lazy :P i just sent him some decals, i should have sent him some **** to motivate him :P

 

wll i have recieved it but i loaded all the soft ware and it still doesnt look like the thing is working i still get a failure 64 byte fult in the flashburn application any help please

 

make sure you d/l the software then the drivers. when you plug in the burner does it recognize it? when you open up flashburn it should say something about the hardware of something. it doesn't say error hardware not found, does it? make sure you are selecting the correct chip that you are burning/reading as well. locate chip in the furthest it'll go away from the lever and the notch at the closest end of the chip to the lever.

 

OK got it working and installed all ok and the car flies 15. lbs. at 4000 rpm and using the (beerbongsickass), bin file very kick *** only thing is the check engine light is on and the idle is low no biggie though,,,,lots of love for the programmer on the beerbongsickass bin file , needs a little tuning and thats it,,,appreciate the help the project is complete (accept for the water injection)....
thanks
cory

 

what do you mean "check engine light is on, no biggie". why do something half ***? get rid of the cel, then brag. boost with no cel's is where it's at if i program an ecu and it runs great but still have a cel, i'm not happy with it until the cel is gone, especially my own car :P what version of ud did you burn bbka's .bin with?

 

UD VERSION 1.6

 

try burning this one, it was converted to 1.7



http://www.ecimulti.org/uberdata/for...;threadid=2056