JUST PURCHASED
#14
Re:JUST PURCHASED
Originally Posted by xenocron
Originally Posted by projekteg
if he sends me an rtp board i'll test
#16
Re:JUST PURCHASED
make sure you d/l the software then the drivers. when you plug in the burner does it recognize it? when you open up flashburn it should say something about the hardware of something. it doesn't say error hardware not found, does it? make sure you are selecting the correct chip that you are burning/reading as well. locate chip in the furthest it'll go away from the lever and the notch at the closest end of the chip to the lever.
#17
Re:JUST PURCHASED
OK got it working and installed all ok and the car flies 15. lbs. at 4000 rpm and using the (beerbongsickass), bin file very kick *** only thing is the check engine light is on and the idle is low no biggie though,,,,lots of love for the programmer on the beerbongsickass bin file , needs a little tuning and thats it,,,appreciate the help the project is complete (accept for the water injection)....
thanks
cory
thanks
cory
#18
Re:JUST PURCHASED
Originally Posted by THRESHOLD
OK got it working and installed all ok and the car flies 15. lbs. at 4000 rpm and using the (beerbongsickass), bin file very kick *** only thing is the check engine light is on and the idle is low no biggie though,,,,lots of love for the programmer on the beerbongsickass bin file , needs a little tuning and thats it,,,appreciate the help the project is complete (accept for the water injection)....
thanks
cory
thanks
cory
#20
Re:JUST PURCHASED