Re: i could use some help on this please
ive got it too work a few times out of a million. i dont know
|
Re: i could use some help on this please
Mine works everytime...
What software version are you using? |
Re: i could use some help on this please
traceminister says its a moates burner i dont know for sure. i am using .97ja. i didnt quite get the steps on your sight. the w27cxx chip i couldnt find??????????? if you could help me out i would greatly appreciate it. :)
|
Re: i could use some help on this please
For the SST chips...its under:
EPROM Electrical Erase --> SST27SFxxx --> SST27SF512 |
Re: i could use some help on this please
thats exactly what i do to get that chip up
|
Re: i could use some help on this please
Then set up the DIP switch like it shows...
Then set up the Jumper (top middle of picture) like it shows. (For Programming) Now to erase te 27SF, you need to add a jumper (like it shows on the PCB board picture, not in software) You might have to erase 1st before burning ;) |
Re: i could use some help on this please
Originally Posted by xenocron
Then set up the DIP switch like it shows...
Then set up the Jumper (top middle of picture) like it shows. (For Programming) Now to erase te 27SF, you need to add a jumper (like it shows on the PCB board picture, not in software) You might have to erase 1st before burning ;) |
Re: i could use some help on this please
LIKE THIS TO BURN
|
Re: i could use some help on this please
LIKE THIS TO ERASE
|
Re: i could use some help on this please
what about jumping 3 to 31. do i need to or not. thanks for the help ;D
|
All times are GMT -5. The time now is 02:06 AM. |
© 2024 MH Sub I, LLC dba Internet Brands