i could use some help on this please
#2
Re: i could use some help on this please
well the invisible burner is a tricky one to use. I would just give up.
I am guessing that you are talking about the burner from your last posts. Go look at projekteg's write-up and when he says to put in AT29C256, instead select the proper #.
I am guessing that you are talking about the burner from your last posts. Go look at projekteg's write-up and when he says to put in AT29C256, instead select the proper #.
#3
Re: i could use some help on this please
invisible burner? that looks like a willem that chip is sittin in....anywhoo assuming you have the the cables and software for the burner, open the software go to "device" go down to eprom electric erase, then over to sst27sfxxx, then over to sst27sf512, select that, then on the software main screen it will show you a picture of the dip switches ( the blue thing with the white switches) then set the dip switches on the burner exactly how they appear in the picture, put you chip in and select "verify", if you did it right a pop up should tell you its an sst27sf512, if so, proceed to load a bin into the burner software, and burn away! good luck!
#4
Re: i could use some help on this please
Originally Posted by boosted_b16
invisible burner? that looks like a willem that chip is sittin in....anywhoo assuming you have the the cables and software for the burner, open the software go to "device" go down to eprom electric erase, then over to sst27sfxxx, then over to sst27sf512, select that, then on the software main screen it will show you a picture of the dip switches ( the blue thing with the white switches) then set the dip switches on the burner exactly how they appear in the picture, put you chip in and select "verify", if you did it right a pop up should tell you its an sst27sf512, if so, proceed to load a bin into the burner software, and burn away! good luck!
#5
Re: i could use some help on this please
my bad you need to click on "ID" not verify....that should work, also make sure the chip is in the burner correctly, the little arrow facing toward the lock down bar, and the chip all the way back on the opposite side of the lock bar...lemme know what happens....
#8
Re: i could use some help on this please
thats weird? i use .97ja.....you can go to action then down to "get id" as well, or try just hitting controll I....see what happens, if you have no luck id'ing the chip, try using the other software, or try just closing the program and re opening.....