how to tell what calibration FMU you got.
#3
Re: how to tell what calibration FMU you got.
you can check vortech's website and they have it posted but if it is not a actual vortech fmu and you want to switch out the plates you will have to grind a little of the interior of the rings for lower ratios...i had to do this on 3 different brand fmus
on a side note though I have run a sfmu with vafc and car ran ok i finally broke down and got turboedit and car is much easier to tune and trouble shoot not to mention I have many more options for adjustment compared to using even a sfmu...
just giving you some advice so you don't do what I did which was basically waste money and time...which will cause you major frustration...
on a side note though I have run a sfmu with vafc and car ran ok i finally broke down and got turboedit and car is much easier to tune and trouble shoot not to mention I have many more options for adjustment compared to using even a sfmu...
just giving you some advice so you don't do what I did which was basically waste money and time...which will cause you major frustration...
Thread
Thread Starter
Forum
Replies
Last Post
Tarzan
Forced Induction
0
06-25-2006 11:18 PM
RotaryGeek
General Discussion
44
01-18-2006 07:00 AM
tukinnam
General Discussion
16
04-20-2005 10:19 PM
draztik
Engine Management
2
06-15-2004 08:07 AM