how do i read sst 27sf512 on a willems?
#21
Re: how do i read sst 27sf512 on a willems?
so you have a bin, you burned it to the chip. then you read the data off the chip to a new bin, deleted the y's and compared the two and they were not the same?
is that what is going on? im trying to make it more clear.
-Luke
is that what is going on? im trying to make it more clear.
-Luke
#22
Re: how do i read sst 27sf512 on a willems?
Originally Posted by MAJORAHOLE
no, i found the one i burned to it and it wasn't the same. whats goin on here? am i ------ up on the deleting y's out the the bin?(doesn't seem to be that hard)
I don't know anything about editing roms in notepad. I have used prog-studio and didnt ---- it up, cause you just type in a start and stop addy to remove. then compare it to the original bin (preburn with no offset) and it will tell you any differences.
#24
Re: how do i read sst 27sf512 on a willems?
Yeah, I've never had any issues using my hex editor either to erase the blank code. I just erase the blanks, copy the rest of the info, and paste it into a new .bin file so I can start at the 0000 mark.
#27
Re: how do i read sst 27sf512 on a willems?
Originally Posted by MAJORAHOLE
do i have to get rid of ALL of the y's cause i still leave some a tthe bottom??
#28
Re: how do i read sst 27sf512 on a willems?
Originally Posted by MAJORAHOLE
do i have to get rid of ALL of the y's cause i still leave some a tthe bottom??
-Luke
Thread
Thread Starter
Forum
Replies
Last Post
racepak
Engine Management
10
01-19-2007 10:05 PM
idiot-stick
Engine Management
6
10-25-2005 12:14 AM