getting closer to running
#1
getting closer to running
ok guys i need some help
my base timeing is set, its right on, but revving the motor something is retarding (i think) the timeing pretty bad, i had it set to 16 BTDC, and with the motor above 2K it starts headin south... to the left (from the drivers side) of the crank pullys mark and falls on its face
anyone got any ideas to fix this and get it runnable?
my base timeing is set, its right on, but revving the motor something is retarding (i think) the timeing pretty bad, i had it set to 16 BTDC, and with the motor above 2K it starts headin south... to the left (from the drivers side) of the crank pullys mark and falls on its face
anyone got any ideas to fix this and get it runnable?
#4
Re: getting closer to running
yes, its dead on, but im a dumbass anyway
somethin else is my problem... i have no clue what it could be though so im selling the car and getting something for a DD then getting a project that i can actualy waste time on.. was stupid to build my DD without a back up car
somethin else is my problem... i have no clue what it could be though so im selling the car and getting something for a DD then getting a project that i can actualy waste time on.. was stupid to build my DD without a back up car
Thread
Thread Starter
Forum
Replies
Last Post
HMT-Roger
General Discussion
0
11-06-2011 02:46 PM
96_civ
Forced Induction
36
10-04-2005 08:30 PM
robs99si
General Discussion
4
08-14-2004 11:52 PM