Y-49crx

//
It says on they're website that all the programmers come with the licenced software. However, I lost mine. I ordered my programmer through the group buy here on HMT. Can someone please help a brother out?

Please PM me

Thanks.
//

I posted this in at the end of another similar thread but had no replies.

While trying to burn a stock pm6 bin using the batronix 4 programmer. I get this error message



I've tried burning multiple different bins also. Does anyone have an idea of what could be causing this problem?

Thanks. Joe

SpankedYA!

Sure you have the chip in correctly?

Y-49crx

yes, i have the pins and the chip set-up just like the diagram shows.

Bongnak

is it a 27c256? if so make sure you have changed the type of chip you are using in the "programmer" button up top in prog-studio. select 27c256. if that doesnt work throw that chip away cuz they suck i hate them. then go to moates.net and order 29c256.


also check the red jumpers if you have the batronix burner and is the software fully registered?

Y-49crx

im using an at29c256 chip. I have the correct chip and programmer selected. Could the software being not fully registered cause this?

-Joe

Bongnak

yeah it tells you that it will only burn a limited amount on there so yeah thats your problem bud

Y-49crx

thanks for the replies. It says on they're website that all the programmers come with the licenced software. However, I lost mine. I ordered my programmer through the group buy here on HMT. Can someone please help a brother out?

Please PM me

Thanks.