ECU stop to read chip
**Setup LS turbo with 450cc and uber
**Note: I use the car at weekends only and i disconnect the battery every week
Few weeks ago when i was cruising with some friends the car starts to fail very bad, throwing a lot of black smog. I stop the car and disconnect the battery for some minutes and i connected again, and problem gone.
Next week the car starts ok but some hours later do the same, i do the same battery thing but the problem came back again quickly.
Yesterday i start the car and starts failing, so i think that was the jumper maybe, so i change it but problem aint go.
I remove the jumper from the ecu and the car acts the same as with the jumper
Then i burn again two different chips with same program and i try with both but didn't works.
I put back the stock 240cc and the car starts ok, with and without the jumper
.
Wich could be the problem?
**Note: I use the car at weekends only and i disconnect the battery every week
Few weeks ago when i was cruising with some friends the car starts to fail very bad, throwing a lot of black smog. I stop the car and disconnect the battery for some minutes and i connected again, and problem gone.
Next week the car starts ok but some hours later do the same, i do the same battery thing but the problem came back again quickly.
Yesterday i start the car and starts failing, so i think that was the jumper maybe, so i change it but problem aint go.
I remove the jumper from the ecu and the car acts the same as with the jumper
Then i burn again two different chips with same program and i try with both but didn't works.
I put back the stock 240cc and the car starts ok, with and without the jumper
.Wich could be the problem?
Originally Posted by xenocron
Bad resistor box?
But im going to check the resistor box on a friend's car
Thread
Thread Starter
Forum
Replies
Last Post
canadianmade
General Discussion
0
Jun 1, 2005 11:36 AM
Johnyquest
Engine Management
1
Jan 12, 2004 09:50 PM
digitalhav0c
Engine Management
5
Aug 17, 2003 09:21 PM



