ecu info***update***XENOCRON CHECK IN!!!!
#22
Re: ecu info
ok well the ecu i guess is a auto pr5. ive seen some ways to convert ecus from and auto to a manual, but not specifically for the pr5. xeno, any clue?
found that pgmfi.org has a page, but the cache doesnt go that far crap
also found this page. http://honda-tech.com/zerothread?id=1275452&page=1
i know, its honda-tech...........but its a resource.
i just found this pic and was wondering if it will work. the ecu looks exactly like this one. only difference is that ecu is a pm7 and mines the pr5. same difference correct?
found that pgmfi.org has a page, but the cache doesnt go that far crap
also found this page. http://honda-tech.com/zerothread?id=1275452&page=1
i know, its honda-tech...........but its a resource.
i just found this pic and was wondering if it will work. the ecu looks exactly like this one. only difference is that ecu is a pm7 and mines the pr5. same difference correct?
#27
Re: ecu info***update***XENOCRON CHECK IN!!!!
Originally Posted by xenocron
28 pins, yes.
carefully remove that 28 pin chip and solder in a DIP socket in its place
carefully remove that 28 pin chip and solder in a DIP socket in its place
Not sure what the ecu guru does on those but I actually remove the chip by cutting it out so I dont have to pull up on the chip when removing it
then just use needle nose when the pins get lose to remove them or most f the time they will just fall out by themselves after desoldering
Thread
Thread Starter
Forum
Replies
Last Post
Shreik
Wanted
7
04-24-2006 01:38 PM