ECU control, need help!
#1
ECU control, need help!
I have a chipped PM6 ecu with a USB datalogging cable. Anyway, I just got a laptop. I plugged the usb cable in to my laptop, turn it on, started the car, ran ecu control and none of the gauges work or datalogging?? I'm using a ng55 1.8 map with imported pm7 ign. and fuel maps. I set the ecu to ng55 and tryed a few diff. com ports and nothing?? Please help??
#2
Re: ECU control, need help!
Use the newest NG code (NG60) and use the newest version of ECU Control
www.ecucontrol.com
Then report back after you are using the latest and supported version of everything.
www.ecucontrol.com
Then report back after you are using the latest and supported version of everything.
#5
Re: ECU control, need help!
NG60 code
http://forum.pgmfi.org/viewtopic.php?t=5980
ECU Control
http://forum.pgmfi.org/viewtopic.php?t=5967
As far as figuring out what port to use, if its serial...most likely its COM1
If its USB, you have to look in your device manager. if you dont know how to do that, check out Windows HELP r do a Google search.
http://forum.pgmfi.org/viewtopic.php?t=5980
ECU Control
http://forum.pgmfi.org/viewtopic.php?t=5967
As far as figuring out what port to use, if its serial...most likely its COM1
If its USB, you have to look in your device manager. if you dont know how to do that, check out Windows HELP r do a Google search.
#6
Re: ECU control, need help!
^ thanks. I actually found the driver and ng60 bin last night. I hooked up last night and it sick! My com port is 4( I just kept trying ports untill it worked). The rpms where exactly the same.
Thread
Thread Starter
Forum
Replies
Last Post
Mosaic
Forced Induction
0
01-02-2010 11:42 AM
steelcityhonda
Engine Management
21
08-18-2004 06:37 PM
89dxhunchback
Forced Induction
5
06-03-2004 02:19 PM