d16z6 chiping problems
#1
d16z6 chiping problems
hey ive got a chiped z6 with a ihi-rhb5 on 12 psi
ive put a on off switch on the j1 so i could turn it on or of whenever i want to
well the thing is that wen i turn on the switch (beerbongs bin)
the cel dosent go and the car starts to hav starting problems
and when i start the car it only goes up 4krpm and cuts out
looks like limp mode
and then when i turn of the switch
the car starts properly and the rpm goes to the limiter
so y does the cel dosent go and y is there the 4k cut off
bad chiping?
bad bin?
plz help
thanx
ive put a on off switch on the j1 so i could turn it on or of whenever i want to
well the thing is that wen i turn on the switch (beerbongs bin)
the cel dosent go and the car starts to hav starting problems
and when i start the car it only goes up 4krpm and cuts out
looks like limp mode
and then when i turn of the switch
the car starts properly and the rpm goes to the limiter
so y does the cel dosent go and y is there the 4k cut off
bad chiping?
bad bin?
plz help
thanx
#7
Re: d16z6 chiping problems
hmmm ye it dosent go away
n im running on 440's frum a 7mgt with 10ohm10wat resistiors
the only thing that happens is that i get alot of black smoke n tats cause of the injectors
ill check the chiping again
btw could the 74HC373 be screwed up or summin?
neways has anyone tried beerbongs uploaded bin?
or is their any other 12psi bin with great outcomes like beerbongs?
or could their b ne problems in my ecu??
thanks
n im running on 440's frum a 7mgt with 10ohm10wat resistiors
the only thing that happens is that i get alot of black smoke n tats cause of the injectors
ill check the chiping again
btw could the 74HC373 be screwed up or summin?
neways has anyone tried beerbongs uploaded bin?
or is their any other 12psi bin with great outcomes like beerbongs?
or could their b ne problems in my ecu??
thanks
#8
Re: d16z6 chiping problems
hmm n btw
could their b ne problem in the 1k resistor? or the capasitors?
if yes
then how do i find the one tats creating the prob
ne help would sure help me alot
thnx
n ya mr.beerbong
wuts yr msn email addy?
could their b ne problem in the 1k resistor? or the capasitors?
if yes
then how do i find the one tats creating the prob
ne help would sure help me alot
thnx
n ya mr.beerbong
wuts yr msn email addy?
#9
Re: d16z6 chiping problems
beerbongs bin has been used by alot of people, its not the problem. you either got a bad solder at the ecu, or you are using a williams burner and didnt set it up right. is this the first time you have burned a chip just curious, the first few i did i didnt set the ID of the chip right and kept getting solid CEL's. i would it w/out the switch, b/cause you wont be able to run the stock maps on the bigger injectors anyways.